![]() ![]() Requires: 1 x BBC micro:bit and a terminal block screwdriver.īBC Micro:Bit available as an optional extra. The BBC micro:bit can face in either direction and all the terminal blocks will be fully functional. In addition, the micro:bit can be easily attached through the mounting holes on the strip. All have standard footprints and are tape and reel packaged. The micro:bit terminal strip makes it easy to connect sensors. To use the Terminal Breakout board, firmly insert the micro:bit into the edge connector in the center of the board. micro terminal blocks offer an ultra-low profile and multiple configurations. Thus providing some overcurrent protection for the BBC micro:bit. If the micro:bit is powered via its USB connector, there is no power at the 3.3V terminal block output connections. The board has no voltage regulator or overvoltage protection, so the supply voltage MUST NOT exceed the rated supply of 3.3V for the BBC micro:bit. The input terminal block serves as a power supply. PLOTMARK, mounting type: snapped, for terminal block width: 4 mm. This Kitronik Terminal Block Breakout Board features a terminal block breakout point for each BBC micro:bit IO pin, a switch-controlled input power terminal block, two output power terminal blocks (fed through power from the switched input) and also Link compatible connections for other BBC micro:bit accessory boards. voltage: 400 V, nominal current: 17.5 A, connection method: Screw. Simply cut a length of wire from one of your spools, strip off some shielding, and screw it into place. There will be no more untangling M/M or M/F jumper cables with this terminal block. The Kitronik Terminal Block Breakout Board for BBC Micro:bit breaks out all the signal and power pins to user-friendly terminal blocks.
0 Comments
Leave a Reply. |